Pedrollo RX Vortex Stainless Steel Submersible Water Pump

Description

Pedrollo RX Vortex Stainless Steel Submersible Water Pump

INSTALLATION & USE

The RX-VORTEX series are suitable for use with dirty water. They are suitable for use in domestic applications such as for discharging dirty water containing suspended solids. The design solutions that have been adopted, such as the complete cooling of the motor, guarantee the reliability of the pump.

Typical Applications

A Dirty Water Pump is used for removing water that is likely to contain some solid particles. Typical examples of dirty water would include flood water, muddy water, pond water, home waste water which is not filthy etc. Take care to note the maximum solids the pump can deal with to make sure you make the right selection.

CONSTRUCTION

Pump Body: Stainless steel AISI 304 with threaded port in compliance with ISO 228/1
Suction Filter: Stainless steel AISI 304
Diffuser: Stainless steel AISI 304
Impeller: Stainless steel AISI 304 VORTEX type
Motor Casing: Stainless steel AISI 304
Motor Casing Plate: Stainless Steel AISI 304

Motor Shaft: Stainless steel EN 10088-3 – 1.4104

Port:
1’1/4″ RX2/20, RX 3/20
1’1/2″ RX4/40, RX 5/40

Supplied with Hose Connector with Union (Hosetail): ø 35mm

The pumps are complete with:
– 5 m long power cable for RX2/20, RX 3/20
– 10 m long power cable for RX4/40, RX 5/40
– float switch for single-phase versions

PERFORMANCE RANGE

Flow rate up to  280 l/min (16.8 m³/h)
Head up to 9.5m

APPLICATION LIMITS

Immersion Depth: 10m (with a sufficiently long power cable)
Maximum liquid temperature: +50 °C (maximum liquid temperature +90 °C for a maximum of 3 minutes of intermittent service)
Passage of suspended solids up to
ø 20mm for RX2/20, RX 3/20
ø 40mm for RX4/40, RX 5/40

Suction level;
– 25 mm above ground level for RX2/20, RX 3/20
– 50 mm above ground level for RX4/40, RX 5/40
Continuous Service S1

Additional information

Performance Data

Downloads

RX Vortex Datasheet